The Most Common Errors While Using A Sewing Machine – Part Two

In my last article, I attempted to take on some of the most common problems that people complain about in sewing machine reviews and give a solution to these problems. Once I finished however, I realized that I had missed quite a few common problems, so I have decided to do a second part to my original article and attempt to address them today. Here are the most common sewing machine problems and their solutions, part two. Enjoy.

Problem #4: My Machine Punches Holes In My Fabric

If you are attempting to sew and your machine is trying to make Swiss cheese out of your fabric, then you are most likely using the wrong needle. Needle choice is the absolute most important choice you can make. And torn up clothing isn’t the only problem with using the wrong needle. If you have the wrong needle inserted into your machine, then you can have a wide array of problems. You can mess up the timing on your machine, throw a bobbin or damage your bobbin hook. That is why it is absolutely necessary to choose the right needle for the machine, the stitch you are doing and the fabric you are stitching.

Problem #5: My Stitches Are Too Tight

If you are sewing and notice that your stitches are a little too tight on the top, then you have a problem that needs to be addressed immediately. Sometimes this problem arises because the tension isn’t correctly set on the machine, but that isn’t always the case. Sometimes it’s a mistake you made while threading the machine.

When you wind the bobbin, you often place the end of the thread on the tension disks—which is standard practice. However, you also have to make sure that you remove it before you start sewing. If you don’t, then you often end up with a stitch that is way too tight. And that is no good for anyone.

Problem #6: My Thread Keeps Knotting

If your thread keeps knotting and are creating problems with your garment or jamming up your machine, then you might have a problem with one or more parts of your machine. First, you want to make sure that your thread is sticking out of the back of your sewing machine. Second, start your sewing a little further from the edge. If there isn’t enough fabric when you start, then it can cause the thread to knot up. Don’t worry though, you can always backtrack to give take your stitches all the way to the edge. Just be sure that you don’t go over the edge and then try to back track because that will also knot up your threading. Be vigilant and you should be alright.

And that concludes my article on the best sewing machine solutions for the most common problems. If I think of any more, then I will be sure to write another article, but I do think that this two part articles covers most of the primary ones.


Leave a Reply

Your email address will not be published / Required fields are marked *