5 Most Frustrating Sewing Machine Problems

I think it has happened to all of us at one time or another. You are right in the middle of a big sewing project and then your best sewing machine begins to act up. It might pop a bobbin, or the thread begins to not look right. And this usually happens at the most difficult or critical stitch. It just seems like your machine has turned against you and you will never get the project finished.

Sewing machine problems can be really frustrating. Especially when you feel like you have done everything right. You have maintained your machine the proper way and you have been following all the best practices. Yet it still happens. Regardless of preparation, skill level or attention to detail.

Even though you can’t really prevent every single unfortunate glitch that happens while you are sewing, you can take steps to correct them when they do happen. Today, I am going to cover some of the biggest and most frustrating problems that may arise with your machine and give you some quick fixes to correct them. Hopefully, this will save you at least some aggravation.

#1: Thread Problems

Sometimes you are just going along and your threading doesn’t look right. The stitches are too loose or too tight, or there is some other problem going on. In these instances, you might have a tension problem and need to re-thread the machine.

#2: Check The Bobbin

If re-threading the machine doesn’t work, then you might want to check your bobbin. A bobbin that is too tight or too loose can cause a myriad of different problems.

#3: Check The Machine’s Hygiene

If the above two steps doesn’t correct the problem, then your machine might be a bit dirty. Yes, I know. You thought you have been keeping up on minor maintenance, but sometimes due to the amount of work you have been doing on the machine it gets a little dirtier than usual and you need to clean it up a bit.

#4: Do You Have A Broken Part?

Okay, you have re-threading your machine, checked the bobbin and cleaned your sewing machine, but it still isn’t working correctly. If that is the case, then you might want to check for broken parts such as a broken bobbin or a bent needle.

#5: Am I Using The Wrong Thread Or Needle?

Sometimes the problem with your machine is that you are using the type of thread or needle. Always be sure that you are using the right needle and thread for the material and the project you are working on to avoid these problems. You should also check that you aren’t using two different types of thread. One time I was working on a project and started having problems, so I checked the thread and realized that the spool and the bobbin had different types of thread.

Check these five points and see if they are causing your frustration. Whenever I see complaints in sewing machine reviews about a particular machine, it is usually one of the five points that is causing the problem. Correcting them can really save you a lot of peace of mind.


Leave a Reply

Your email address will not be published / Required fields are marked *